Nowadays, the studies of parameter calibration for long-term work zones are limited to driver behaviour and car-following parameters, and no research was found related to calibration of the desired speed distributions during temporary work zones. Obtaining realistic results from simulations of temporary work zones is difficult. Thus, it would be valuable for gaining more valid simulation data if a method of calibrating the desired speed distribution could be applied for traffic simulation model of highway temporary work zones. The calibration method was proposed in five steps: (1) collect and analyse data, (2) plot the travel speed cumulative frequency curves and calibrate the desired speed distribution, (3) conduct simulation runs, (4) validate the simulation results, and (5) propose a new calibration method, which was assessed by T-tests, and the results are very promising. Finally, a simplified calibration method called “Five-Point Method” is presented and the recommended values of five-point are given.
Schonfeld P, Chien S. Optimal work zone lengths for two-lane highways. Journal of Transportation Engineering. 1999;125(1):21-29.
Asad JK, Aemal JK, Forrest MC. Effects of Work Zone Presence on Injury and Non-injury Crashes. Accident Analysis & Prevention. 2002;(34):19-29.
Rouphail NM, Yang ZS, Fazio J. Comparative study of short-and long-term urban freeway work zones; 1988.
Pigman JG, Agent KR. Highway Accidents in Construction and Maintenance Work Zone. Transportation Research Record: Journal of the Transportation Research Board. 1990;1270:12-21.
Summary Report on Work Zone Accidents. Standing Committee on Highway Traffic Safety. American Association of State Highway and Transportation Officials; July 1987.
Park BB, Schneeberger JD. Microscopic simulation model calibration and validation: case study of VISSIM simulation model for a coordinated actuated signal system. Transportation Research Record: Journal of the Transportation Research Board. 2003;1856:185-192.
Yu L, Chen XM, Wan T, Guo JF. Calibration of VISSIM for Bus Rapid Transit Systems in Beijing 23 Using GPS Data. Journal of Public Transportation. 2006;9(3):239-257.
Hollander Y, Liu R. The principles of calibrating traffic micro simulation models. Transportation. 2008;35(3):347-362.
Benekohal RF. Procedure for validation of microscopic traffic flow simulation models; 1991.
Hellinga BR. Requirements for the calibration of traffic simulation models. Proceedings of the Canadian Society for Civil Engineering. 1998;4:211-222.
Lee DH, Yang X, Chandrasekar P. Parameter Calibration for PARAMICS Using Genetic Algorithm. Transportation Research Board 80th Annual Meeting, 2001 Jan 7-11; Washington, DC.
Richard D, Joseph H, Allen H. Guidelines for Applying Traffic Simulation Modeling Software. Oakland, CA: Dowling Associates Inc; 2002.
Hourdakis J, Michalopoulos PG, Kottommannil J. A practical procedure for Calibrating Microscopic Traffic Simulation Models. Transportation Research Board 82nd Annual Meeting, 2002 Jan; Washington, DC.
Gomes G, May A, Horowitz R. A Micro-simulation Model of a Congested Freeway using VISSIM. 83rd Annual Meeting of the Transportation Research Board, 2004 Jan 11-15; Washington, DC.
Jian S, Yang XG. Research into Microscopic Traffic Simulation Model Systematic Parameter Calibration: A Case Study of VISSIM. Computer and Communications. 2004;3.
Jie S. Evaluations of Traffic Simulation Models: CORSIM and SimTruck. Nova Scotia, Canada: Dalhousie University; 2005.
Yang H, Han SF, Chen XH. The application of parameters calibration in Vissim. Journal of Urban Transportation. 2006;4(5):22-25.
Li ZM, Yan XY. A calibration method for micro-simulation based on Genetic Algorithm. Journal of Transport Standardization. 2006;4:21-23.
Ciuffo BF, Punzo V, Torrieri V. A framework for the calibration of microscopic traffic flow models, Transportation Research Board 86th Annual Meeting, 2007 Jan 21-25; Washington, DC.
Jian S, Yang XG, Liu HD. The calibration study of Micro-simulation model. Journal of System Simulation. 2007;19(1):48-50,159.
Chitturi MV, Benekohal RF. Calibration of VISSIM for Freeways. Transportation Research Board 87th Annual Meeting, 2008 Jan 13-17; Washington, DC.
Lee JB, Ozbay K. Calibration of a Macroscopic Traffic Simulation Model Using Enhanced Simultaneous Perturbation Stochastic Approximation Methodology. Transportation Research Board 87th Annual Meeting, 2008 Jan 13-17; Washington, DC.
Li YX. The analysis and modeling of capacity of expressway with bus lane based on Micro-simulation. Beijing Jiaotong University; 2009.
Yang W. Study on the relationship between the access of urban expressway and bus station based on Micro-simulation. Beijing University of Technology; 2010.
Ting H. Calibration of microscopic traffic simulation model for weaving sections expressway. Beijing Jiaotong University; 2010.
Yu Z, Lei Y, Zhao NL, Zhu LY, Chen XM. The study of SPSA used to calibrate parameters in Vissim. Journal of Transportation Systems Engineering. 2010;10(4):44-49.
Zhang CC, Niu XQ. Parameter calibration of VISSIM model for intersection based on orthogonal experiment. Transportation Science & Technology. 2011;(2):110-113.
Quan Y, Meng W, Deng XH. Simulation parameter calibration of single signal intersection based on orthogonal experiment. Journal of Highway and Transportation Research and Development. 2012:57-63.
Liu CC. The study of road safety in work zone based on simulation. Southwest JiaoTong University, Chengdu, China; 2012.
Hu XH, Yu Z. Parameters calibration method for large scale traffic simulation network based on SPGA algorithm. Journal of Educational Institute of Jilin Province. Richards SH, Dudek CL, Implementation of work zone speed control measures. Transportation Research Record: Journal of the Transportation Research Board. 1986;1086:36-42.
Virginia PS, Richard WL. Study of Speed Patterns in Work Zones. The 78th Annual Meeting of the Transportation Research Board, Washington, DC, revised. 1999:978-992.
Migletz J, Graham JL, Anderson IB, et al. Work Zone Speed Limit Procedure. The 78th Annual Meeting of the Transportation Research Board, Washington, DC. 1999:584-596.
Park BB, Qi H. Development and evaluation of a calibration and validation procedure for microscopic simulation models. Charlottesville, Virginia: Virginia Transportation Research Council; 2004.
Zhao XF, Huang ZY, Lin HF. The effects of traffic delay on desired speed distribution. Journal of Transportation and Computers. 2007;24(6):84-87.
Peng WX, Yuan X, Guan JX, Dong HL. The profiles of travelling speed based on simulation in Vissim. Journal of Hebei Jiaotong College. 2007;4(4):57-60.
Peng WX, Yuan X, Guan JX, Dong HL. The profiles of travelling speed based on simulation in Vissim. Journal of Hebei Jiaotong College. 2007;4(4):57-60.
Guest Editor: Eleonora Papadimitriou, PhD
Editors: Dario Babić, PhD; Marko Matulin, PhD; Marko Ševrović, PhD.
The mission of our journal is to provide high quality communication of research results, which is crucial for the effectiveness of scientific research, the promotion of scientific information, new ideas, and original research in the field of traffic and transportation engineering.
1848-4069
0353-5320
Proud publisher
Accelerating Discoveries in Traffic Science |
2024 © Promet - Traffic&Transportation journal
